ParseError: syntax error, unexpected 'include' (T_INCLUDE), expecting identifier (T_STRING) or '{'
More info is available in the error log.
**Dies ist eine alte Version des Dokuments!**
Urchin
Do you really need a PCB to run the MicroBox Circuit Diagram?
Actually not. In your office, have a coffee and take the stick you stirred with, then grab a few paper clips, 33k resistor, MSP430G2553 programmed with Forth, Socket, 5 LEDS.
A bit of cable and a 4-6 pin connector to the USB-to-TTL interface, or the 4 relevant pins from the TI Launchpad.
( the extra 4 resistors soldered onto the back leg are just for later, to add in line with the 4 OUT LEDs, to get the full output swing if external IO has to be addressed.)
A bit of bending and soldering - Extra 2 resistors on the 3 legs connected to GND, IN0 and IN1 as switches. Thats it.
Run the 4e4th-IDE and program in the uMMT code, run it.
Finished and tested.
Have a good Sunday.
Juergen Pintaske www.exemark.com